iPulse PoE®

Product Details

Model iPulse PoE

Tested to compIy with FCC Standards

iPulse PoE offers the same features as the iPulse, but also eliminates the need for an external power source, providing power over ethernet (PoE) to network devices.

iPulse PoE, a small easy-to-use patented device that connects to a network device, IP camera, router, or wireless/wired modem and monitors the output of the digital signal. If the signal is interrupted, the iPulse sends a command to restart the camera, eliminating the need for a manual reset.

Because processors in IP cameras can lock up, they must be reset. If this must be done manually, it may not be a simple task, especially when the camera is not easily accessible.

iPulse PoE easily connects to your IP cameras and monitors them continuously. If the camera fails, iPulse automatically 'reboots' the camera. iPulse lets you focus on the video while it watches the cameras.

iPulse PoE ®  - Techincal Specifications

• RJ-45 PoE Power and Data Out
• RJ-45 PoE Switched Power and Data Out

IPulse-PoE Power Requirements

• Power provided by PoE Source
• Typical Operating Current: 5 ma
• Peak Operating Current: 12 ma (during power down)

I/O Detect Input

• Input Voltage: -25VDC to +25VDC
• Input Drive Current: 5ma
• Threshold: +1 .9 VDC
• 110 Cable length: 6" or I5.2cm

Intelligent Moded Detection

• IP-1PoE: 5 Minutes
• IP·2PoE: 90 Seconds

Timer Mode Reset Cycle

• 12 Hours

Power Reset Period

• 5 Seconds

Environmental

• Temperature: -22 to 185 Degrees F ( -30 to 85 Degrees C )
• Humidity: 5 to 95 % non-condensing

Dimensions

• Enclosure: 3.15" x 1.5" x 0.79" ( 80mm x 40mm x 20mm )